Technical Library

Certified Hardware & Software

Netopia Routers

LAN-Dial

Router Setup Packet


Setup

Wiring Diagram

Configuration

Custom Configuration

Troubleshooting

Routing with Netopia R2121 for LAN-Dial Service

Setup Instructions

The Netopia R2121 requires only 3 connections:

1. Connect the Ethernet Cable (RJ45) from one of the Ethernet ports on the back of the router to your LAN. Use a straight through RJ45 cable if you're connecting to a hub or a cross over RJ45 if you're connecting directly to an Ethernet card in your PC.
   
2. Connect your analog cable (RJ11) from the Telco 1 port on the back of the router to the analog wall jack.
   
3. Connect the power cord and wait a few minutes while the router completes it's bootup process. Then check the link lights on the front panel.
   
4. Ethernet Hookup Diagrams:
   • PC - Straight-Through to Router (Port 1)
   • PC - Crossover to Router (Port 1)
   • Hub - Straight-Through to Router (Port 1)
   • Hub - Crossover to Router (Port 1)
   • PC to Router (Port Other Than 1)
   • Hub to Router (Port Other Than 1)

Hooking up a Console to the Netopia

To connect a terminal to the Netopia, use a standard serial cable, connecting one end to the Netopia's Console port and the other end to a machine's serial port or modem port, whichever is applicable.

Be sure your emulation software is set to:

• Emulation... VT100
• Baud Rate... 9600
• Bits per Character... 8
• Stop Bits... 1
• Parity... No Parity
• Flow Control... None