Version 2.6.1 Release Notes
8/22/95

This release also includes a limited, line-mode-only telnet server.
To use this limited telnet server add "start telnet" to the config.net
file.  Your telnet client will need to do local echo and local line
editing.

Bugs Fixed:

1.	panel keybeep setting not correctly saved.

2.	entering an unknown command with onrsh caused a crash.

3.	"cd /" in ftp caused the onramp to crash.

4.	"bogus" interrupts from the Serial Communications Controller
	could cause a crash.

5.	Packets sometimes dropped and memory leaked during processing
	of ARP packets.

6.	Ethernet collision counter sometimes incorrectly incremented
	when OnRamp not transmitting.

7.	Frame Relay LMI packets were not given high enough priority.
	Sometimes when a link was very busy, OnRamp would drop LMI
	packets from its output queue.  This caused the Frame Relay
	switch to incorrectly mark the link down.

8.	The syntax of some ppp lcp commands in ppp.net was incorrect.

9. 	SNMP vendor (enterprise)  I.D. truncated from 1264 to 240.

10.	SNMP system services variable reported OnRamp was a host
	rather than a router.

11.	The command "snmp community set"  (with no arguments
	following "set") correctly disabled sets but caused the "GET"
	community to be reported as the "SET" community by the
	"snmp list" command.

12.	The SNMP cold start trap was not sent at boot time even though
	the command "start snmp" was in config.net.

13. SNMP incorrectly reported some interface statistics such as
	output queue length.  

Please Note: Imatek's have v2.3 built in. If the upgrade is
unsuccessful, or there is some other problem with the Firmware
running in Flash Memory, the Imatek will boot with v2.3. In
addition, SNMP was not made available until v2.4.