Ascend Pipeline 50
Routing with Ascend Pipeline 50 for LAN-ISDN Service
MPP Configuration
Configuring One B Channel
Dynamic Allocation
Constant Increase in Bandwidth
This is for enabling the Pipeline 25, 50, or 100 to use one B channel and dynamic bandwidth allocation.
Make sure you are in the Main Edit Menu.
- Select Ethernet
- Select Connections
- Select Net
Under Ethernet, Connections, the Net menu should look like:
---------LI00xxx EDIT-----------
|20-101 |
| Station=Net |
| Active=Yes |
| Encaps=MPP |
| Dial #= |
| Route IP=Yes |
| Bridge=No |
| Dial brdcast=N/A |
|>Encaps options... |
| Ip options... |
| Ipx options... |
| Session options... |
| Telco options... |
| |
| |
| |
| |
Go under the Encaps options and make sure the values are set
to the following:
------ LI00xxx EDIT ----------- ------ LI00xxx EDIT -------------
|90-101 | |90-101 |
| Encaps options... | | Encaps options... |
| >Send Auth=PAP ^| | >Sec History=15 |
| Send PW=******* | | Add Pers=5 |
| Recv PW= | | Sub Pers=10 |
| Base Ch Count=1 | | Target Util=70 |
| Min Ch Count=1 | | Idle Pct=0 |
| Max Ch Count=2 |
| MRU=1524 |
| LQM=No |
| LQM Min=600 |
| LQM Max=600 |
| Link Comp=Stac |
| VJ Comp=Yes |
| Dyn Alg=Constant |
| Sec History=15 v|
| |
| |
Note: Please see Recommended Usage.
The only field that should be changing should be the Dyn Alg field. By changing it to Constant, the Ascend will treat all samples of bandwidth usage equally.
If you need to allocate bandwidth at a faster rate, please see:
Dynamic Allocation: Quick Increase in Bandwidth
If you would like to have both channels dial up whenever you connect, please see:
Configuring Two B Channels.
Once you have done this, you will need to break your current connection and dial in again.
For full configuration information please see Configuring the Pipeline.
|
